10W laser reduced intensity using inline mode

[Delimanator]

I submitted this on the Luban side, but I think it is more meant for firmware. Ever since the change to using inline mode the 10W laser seems to be running at reduced effectiveness by approximately 15-20%

I’ve loaded Luban 4.8.2 to generate a file and run the engrave and then run the same file with all the same parameters on any newer version of Luban to generate the file with inline mode and on the same material it’s a large difference.

Example is before inline mode, 8% is what I used to do nice engraved on cardboard, inline mode with 8% it doesn’t even leave a mark. I’ve also confirmed this with doing a test piece for power and speed factors.